Fluke 83-5 Digital Multimeter for Industrial Applications

• Fluke 83-5 Digital Multimeter for Industrial Applications
• Measure up to 10 Amps, 20 Amps for up to 30 sec.
• Frequency to 200 kHz and % duty cycle
• Resistance, continuity and diode testing capabilities
• 10,000 & mu F capacitance range for components and motor caps
• Min/Max/Average recording with Min/Max Alert to auto-determine fluctuations
• Peak-capture to store transients as fast as 250 & Icirc & frac14 s
• Relative mode to eliminate test lead intrusion from low ohms readings
• Automatic/manual ranging to get the most use out of the product
• Touch Hold to seize stable measurements and avoid noisy signals
• Analog bargraph for fast altering or unsteady signals
• Audible input warning against improper use of input jacks
• Enhanced selectable sleep mode for battery longevity
• Access door for quick battery swaps without breaking the calibration seal
• "Classic" design with new detachable holster that has internal test lead and probe storage places
• Protected to the 2nd edition of ANSI/ISA S82.01 and EN61010-1 CAT IV 600V and CAT III, 1000 V safety ratings
• Withstand impulses in excess of 8.000 Volts, decreasing the risk of surges and spikes
• Lifetime warranty
• Virtual Product & Clamp Meter Demo

Proposition 65 Warning for California Residents: This product can expose you to chemicals including Benzene, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.