| Specifications: | Trend Networks NaviTEK NT Network and Cable Tester |
| Connectors |
| Test Ports - RJ45 | Used for - Cable Test
- Ethernet Test
Connector type - Lifejack with user-replaceable contacts
|
| System Ports - USB | Used for - Software Update
Class - Host
Connector type - A
USB type – 1.1 |
System Ports - Power
| Used for – Battery charging
- Mains powering via adaptor
Connector type – 2.5mm pin power jack
Polarity – Centre pin positive
Voltage – 12v
Current – 2 amp
Location – Bottom of optional power module
(Not present in standard alkaline battery pack) |
| Controls |
| ON/OFF | Push button - Used for – Power ON/OFF |
| Function Keys | F1 to F3 - Used for – Screen-defined functions |
Navigation Keys
| Cursor and ENTER - Used for – User interface navigation
Escape - Used for – Return to previous menu
Autotest - Used for – Launch of automatic test function |
| Reset | Push button - Used for – Escape from exceptional lockup condition |
| Displays |
| Screen - LCD | Used for – Display of setup functions and results
Location – Front
Size – 2.8 inch diagonal
Type – QVGA Colour
Pixels – 240 x 320 |
| LEDs - Charger LED | Used for – Indication of charging status
Colour – Green
Location – Bottom of optional power module
(Not present in standard alkaline battery pack) |
| LEDs -RJ45 Link LED | Use– ON indicates link UP
Colour - Green |
| LEDs - RJ45 Activity LED | Use – Flashing indicates link activity
Colour – Green
|
| Ports |
| RJ45 - Setup | Auto Negotiation - Enabled
- Disabled
Speed -10Mbps
- 100Mbps
- 1Gbps
Mode - Full Duplex
- Half Duplex
MDI - AUTO
- MDI
- MDIX
Min Rx Size – 19-99 bytes
MAC – Factory set |
| Tests - Ethernet Mode | - Ping6
- Trace Route4
- Trace Route6
- Hub Blink
- Auto (Ping, Trace Route,)
|
| Tests - Cable Mode | - Wiremap
- Tone Generator
- Auto (Wiremap) |
| Service Detection - Detected Services | - PoE (802.3af/at. Not Cisco pre-standard)
- ISDN S
- PBX
- Unknown |
| Cable Tests |
| Wiremap - Setup - Cable Type | Cat3 UTP, Cat3 STP, Cat5 UTP, Cat5 STP, Cat5e STP,Cat6 UTP
Cat6 STP, Cat7, USOC, ETH S1236, ETH S1278, ETH U1236
ETH U1278, IND. M12, COAX RJ59
|
| Wiremap - Setup - Colour Scheme | None, 568A,568B, USOC, TERA |
| Wiremap - Setup - Crossover Allowed | Yes, No |
| Wiremap - Setup - NVP | Fixed 72%
Custom 59% - 89% |
| Termination Type | None - Open
Active Remote - #1 - #12 |
| Tests (No Termination) - Faults | Open circuit by pair
Short circuit by pin |
| Tests (No Termination) - Length of pair | Metres / Feet (Set in System Setup)
Range 100m / 330ft |
| Tone Generator - Setup | Tones – 3
Wire I/D – Tone applied to one of 8 pins relative to the other 7
- Tone applied across one of 4 pairs |
| Tone Generator - Test | Audible tone detected using compatible tone probe |
| Ethernet Tests - IPv4 - Setup |
IPv4 Enable
Addressing
Numerical
| - Enabled
- Disabled |
- DHCP
- Static |
- Address
- Netmask
- Gateway
- DNS1
- DNS2
|
| Ethernet Tests - IPv6 - Setup |
IPv6 Enable
Addressing
Numerical
Network Prefix | Enabled,
Disabled |
Stateful (DHCPv6)
- Stateless
- Static |
- 128bit HEX IP address
- 64 bit
- 128 bit |
| Ethernet Tests - Pingv4 - Setup |
Target
Count
Pause
Length | - Numerical address
- URL |
| - 1 to 999999 |
- 1 to 5 Sec
- 8 to 1000 bytes. |
| Ethernet Tests - Pingv4 - Results |
Info
Tx Count
Rx Count
Delay(ms) | - READY
- IN PROGRESS
- PASSED
- NO RESPONSE
- UNKNOWN HOST |
| - 1 to 999999 |
- 1 to 999999
- Minimum
- Average
- Maximum |
| Ethernet Tests - Pingv6 - Setup |
Target
Count
Pause
Length | - IPv6 address
- URL |
| - 1 to 999999 |
- 1 to 5 Sec
- 8 to 1000 bytes. |
| Ethernet Tests - Pingv6 - Results |
Info
Tx Count
Rx Count
Delay(ms) | - READY
- IN PROGRESS
- PASSED
- NO RESPONSE
- UNKNOWN HOST |
| - 1 to 999999 |
- 1 to 999999
- Minimum
- Average
- Maximum |
| Ethernet Tests - Trace Routev4 - Setup |
Target
Max Hops
Timeout
Type | - Numerical address
- URL |
| - 2 to 100 |
- 2 to 30 sec
- ICMP
- UDP |
| Ethernet Tests - Trace Routev4 - Results |
Info
Hop
Delay(ms)
| - READY
- IN PROGRESS
- PASSED
- NO RESPONSE
- UNKNOWN HOST |
| - Numerical address |
- t1
- t2
- t3
|
| Ethernet Tests - Trace Routev6 - Setup |
Target
Max Hops
Timeout
Type | - Numerical address
- URL |
| - 2 to 100 |
- 2 to 30 sec
- UDP |
| Ethernet Tests - Trace Routev6 - Results |
Info
Hop
Delay(ms)
| - READY
- IN PROGRESS
- PASSED
- NO RESPONSE
- UNKNOWN HOST |
| - Numerical address |
- t1
- t2
- t3
|
| Ethernet Tests - Blink - Test |
| Sequence | - Off/10/Off/100/Off/1000 Mb/s |
| Statistics - IP - Results |
| IPv4 | - Enabled or Disabled
- info: listening, assigned, DHCP failed
- DHCP or Static
- IPv4 Address
- IPv4 Netmask
- IPv4 Gateway
- IPv4 DNS1
- IPv4 DNS2 |
| IPv6 | - Enabled or Disabled
- info: listening, assigned, DHCP failed
- Stateful (DHCPv6) or Stateless or Static
- IPv6 Address
- IPv6 Network Prefix, 64 bit or 128 bit
- IPv6 Link Address
- IPv6 DNS |
| Statistics - MAC |
| Results (Tx & Rx) | - Total Frames
- Total Bytes |
| Statistics - LINK |
| PORT | - PoE Voltage 0 – 60V
- Speed, Duplex |
| PARTNER | – 10M-HD
- 10M-FD
- 100M-HD
- 100M-FD
- 1000M-HD
- 1000M-FD
|
| System- Setup |
| Preferences - Language | English, French, German, Spanish,
Italian, Portuguese, Chinese |
| Auto off | Disabled, 3 mins, 10 mins, 30 mins |
| Backlight | Always On
Dims to 50% after 3 mins |
| Length Units | Meters
Feet |
| System- Software update |
| Upgrade | Via USB |
| System - General Power |
| Battery | Supported Types - Standard power module (4 x AA NiMH cells)
- Alkaline battery pack with 4 AA cells
Autonomy - Up to 5 hours (power module only)
Recharge time – 3 hours (Power module only)
Battery level Indication - Full, 2/3, 1/3, Empty |
| System - Physical |
| Dimensions | Length - 175mm
Width - 80mm
Depth - 40mm |
| Weight | Unit - 0.22kg
Batteries – 0.18kg |
| System - Environmental |
| Temperature | Operating – 0°C to 40°C
Storage – -20°C to 70°C |
| Relative Humidity | Min 5%
Max 90% non-condensing |
| System - Approvals |
| EMC | EN 55022:2006 / A1:2007
EN55024:1998 / A1:2001 / A2:2003 |
| Safety | IEC 60950-1:2005+A1:2009/EN 60950-1:2006+A1:2010 |
|
